Evolution Fury 6 Instrukcja Obsługi Pobierz pdf (Strona 14)

www.evolutionbuild.com

14

12. Ensure the both Allen Keys are removed

and the machine arbor rotates freely.

13. Ensure the blade guards are fully

functional before using the machine.

Note: Spacers and spindle rings should not

be used with this machine and/or blade.

3. Debris collection bag (Optional Accessory)

The Debris Collection Bag should be attached

at the debris extraction port.

1. Slide the frame of the collection bag on to

the outlet of the extraction port, ensuring that it

is ﬁrmly connected.

2. To release the bag, slide the frame in the

opposite direction.

Note: To ensure optimal dust collection, empty

the dust bag when it becomes approximately

2/3 full.

WARNING: Before cutting metal materials, the

collection bag should be removed and replaced

with a blanking plug (not supplied).

Reinstate the dust bag when cutting wood.

4. Fitting the Hold Down Clamp (Fig. 7)

Two sockets (one either side) are incorporated

into the rear of the machines fence.

1. Fit the clamp to the retaining socket that

best suits the cutting application, ensuring that

it is fully pushed down.

2. Tighten the fence thumbscrew to lock the

pillar into the socket.

3. Put the workpiece to be cut onto the saw

rotary table.

4. Adjust the clamp using the thumbscrew

and hand-wheel so that it securely holds the

workpiece to the saw table. Ensure that the

clamp does not foul the blade or any other

moving machine parts.

OPERATING INSTRUCTIONS -

MITRE SAW CONFIGURATION

Disconnect the Table Mitre Saw from the

mains supply and inspect your Saw before

each use.

Note: It is important that the operator is

adequately trained in the use, adjustment

and operation of the machine and has read

this instruction and safety manual before

commencing operations.

WARNING: To reduce the risk of injury,

always unplug the saw before changing or

adjusting any of the machines parts. Compare

the direction of rotation arrow on the guard to

direction arrow on the blade. The blade teeth

should always point downward at the front

of the saw. Check the tightness of the arbor

screw.

In mitre saw conﬁguration the lower auxiliary

guard should be removed from the machine

and safely stored for future use.

The upper blade guard must be secured

to the riving knife using the sprung loaded

locating pin.

The table should be adjusted so that it is in

its upper most position. See section 2 Table

Saw Conﬁguration for adjusting procedure.

In this position the upper blade guard will be

effectively locked down over the crown of

the blade.

1. Releasing the saw head

a) Gently press down on the cutting handle.

b) Pull out the head stop latching knob and

allow the head to rise to its upper position.

(Fig. 8)

Note: The cutting head will automatically

lock in the upper position.

We recommend that when the machine is

not in use the cutting head is locked in its

down position, and the latching knob fully

engaged in its socket.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Komentarze do niniejszej Instrukcji

Brak uwag